OBD-II / Euro 6 Diagnostic Guide · P20E8

P20E8: Reductant (AdBlue) Pressure Too Low

Technical diagnosis and off-road ECU calibration reference for Peugeot, Citroën, Opel, Toyota (EDC17C60, MD1CS003, DCM6.2, DCM7.1) & Mercedes/VAG in DaVinci Ghost v1.0.41.

Start 10-Day Trial · €0.99 Download Windows v1.0.41 Check Your ECU Free

Diagnostic Code Summary · P20E8

P20E8 (Reductant (AdBlue) Pressure Too Low) commonly affects Peugeot, Citroën, Opel, Toyota (EDC17C60, MD1CS003, DCM6.2, DCM7.1) & Mercedes/VAG. Cause: Internal urea pump failure inside the sealed AdBlue reservoir, crystallized urea injector, or pressure sensor drift triggering 'Emissions fault: Starting prevented in 1100 km'. For off-road, motorsport and export testing vehicles, DaVinci Ghost v1.0.41 (DaVinci Deluxe) provides both full subsystem switches (AdBlue/SCR, DPF, EGR, NOx) and selective DTC Table Explorer calibration with built-in CHK/CVN.

Why Deleting P20E8 Alone Is Often Not Enough

A frequent mistake with generic DTC removers is deleting only the diagnostic fault code P20E8 while leaving the underlying state machine (SCR inducement countdown, DPF soot mass model or EGR air-mass closed-loop control) active. Within 20 to 100 km, the vehicle still enters torque limitation or displays a dashboard countdown - now without any diagnostic code to explain why.

In DaVinci Deluxe 1.0.41, enabling the dedicated subsystem switch (such as ADBLUE, DPF, EGR or NOX) alongside AUTO DTC and CHK/CVN properly calibrates both the control strategy and the associated fault code paths for your exact ECU software number.

Bench Calibration Procedure in DaVinci Ghost 1.0.41

  1. Perform any required diagnostic reset via OBD scan tool prior to reading (e.g. resetting DPF ash/soot or AdBlue lock status on bench/vehicle where required by the ECU family).
  2. Read the ECU flash binary and open it in DaVinci Ghost 1.0.41. Inspect P20E8 inside the left-hand DTC Table Explorer.
  3. Enable the appropriate system switch + CHK/CVN, save the file, and write back to the ECU. (Off-road & testing use only.)

Verify your vehicle’s exact controller in the Free Live ECU Checker or start the €0.99 10-day trial.